Self-supporting external blinds

These self-supporting external venetian blinds are needed when fixing the blind pelmet to the façade is not wanted or not possible. You can put together these self-supporting external venetian blinds in our shop configurator and order them. The entire construction is then held completely by the side spacers and is self-supporting. This means the pelmet and head section do not need to be screwed to the façade. Key points at a glance: - motor drive as standard / radio / io radio available for a surcharge - always supplied with a square U-shaped pelmet at no extra cost - reinforced spacers towards the wall / window frame - type EL80N = 80 mm flanged slats, type EL80NF = 80 mm flat slats - type EL71N = 93 mm (surcharge) blackout slats (note the different stack heights) - side guidance always with keder-guided rails, round or square - coupled units with double guide rails available - good heat protection, glare protection or blackout 2 different versions of the sheet metal pelmets, see the drawings below: 2 mm aluminium sheet folded into a square U shape. With the "fitting between the guide rails" option, individual pelmets with two pelmet end plates are fixed to the guide rails using retaining profiles. Visually, the guide rails run through here. With the "pelmet fitted on the guide rails" option, the pelmets are fixed to the guide rails at the ends with pelmet end plates. Visually, the pelmets run through here. The rail types at a glance: All pelmet heights for square U-channel pelmets at a glance. For round U-channel pelmets, add 1.5 cm to this list. All slat types at a glance.